Remove those stubborn hard water stains and rings from your toilet bowl. Some fizzing may occur when the baking soda touches the vinegar.
This works great support this channel if you like what we are doing here is where yo.
How to get hard water stains off of toilet. Sprinkle about a tablespoon of baking soda on a dampened scrub sponge and scrub the area where the paper towel were. Step 1 use a plunger to get as much of the water out of the toilet. Spray the wd 40 on the toilet bowl targeting the stains.
Pour the vinegar and water solution into. Give the wd 40 2 to 5 minutes to dissolve the stains. White cleaning vinegar is perfect for breaking down and removing hard water stains.
Follow these steps to get hard water stains out. You can use both pumice rock and anti static sheet to clean the stains of the chemical products if cleaning went wrong and the toilet has bluish and purple marks of the chemicals. Make a paste by mixing a half of a cup of borax and a proper amount of vinegar.
Wear a pair of gloves and scrub the toilet with the anti static sheet to get rid of even the most stubborn hard water stains. Add enough vinegar until getting a thick paste. The vinegar will have loosened the hard water stains and the baking soda with the scrub sponge will help remove them.
Turn off the valve and drain the bowl. If it s tough going try this. This is necessary so that the hard water stains are not covered by water.
How to remove hard water stains in a toilet using wd 40 remove the water at the bottom of the toilet bowl using a cup or a sponge. Continue spraying on additional cleanser following up by scrubbing until even the most stubborn hard water stains are gone. Having too much water will dilute the cleaning agent and make it harder to remove stains.
Step 2 pour vinegar into your toilet bowl about halfway. For really stubborn hard water toilet stains try using borax paste. They could clog your toilet.
With this stain remover technique you need to dry out the toilet bowl. Shutting off the water to the toilet at the fixture shutoff valve then flush the toilet to drain the bowl. You can use regular white distilled vinegar or there is a cleaning vinegar which is a little stronger.
Remove remaining water with an old towel or cloth to expose the hard water stains. Using a plunger plunge out the water and then grab a towel or paper towel to dry up the excess liquid.